![]() I was able to do this by removing the fuse from the positive feed of the harness (assuming you are using the harness from TRS). It's easier to adjust the fogs, if the headlights are off. With the level below the headlight, you get better illumination of the area, where the headlight illumination kinda crates a dead spot. That's a bit high, the illumination for the fogs should be below the headlight. When I installed my LED fogs, projected illumination was at level with the headlight level of illumination. The passenger side is easier done, if you remove the 2 bottom bolts securing the passenger wheel liner, peel the liner back a little, then a screwdriver and your forearm will be able to reach the adjusting screw. You can adjust the drivers side light just by reaching up with a screwdriver. I have a 2011 so I have no idea, but honestly if it looks ok against a garage door you may not need to do anything: I looked through the manual, how do you re aim them?Īs he retrofit led assembly and I don't know how to link to it, just gotta search Maybe PM him if this doesn't make sense. They are VERY BRIGHT!! The bulb seems to be tipped up a little bit when you look into the lens of it but it is in there correct. ![]() Thanks! I did get the H11's in and they are LED. Search "5th gen led fog bulb" should be first thread that comes up for more info. Sylvania L6024 Basic LED Sealed Beam Headlight Bulb (Pack of 1) - L6024. But you are just increasing to what we have in the 2010-2013 so it shouldn't be blinding to other drivers I would guess. Sylvania H8/H16 LED Fog Light Bulb (Pack Of 2) - H8/H16LED. Might want to reaim them, and keep in mind it is a higher output. So really it's a big upgrade as not only are you going to led but you get a major boost in light output. i believe they were saying that a h11 led would work fine for the h16 and would put out more light. H11 should be the correct bulb for your application."Īctually there was a thread related to this some time ago when an led fog was being released. "The Toyota H16 they are now using isn’t related to the older H16 style that is out there. The lumens for the Osram H16's are in the low to mid 700's. I have no clue if the wiring will handle the load though. 12V 55 watts People have installed them, so you must make that decision. The H11 bulbs have the same tabs and will fit in the fog sockets, but will be much brighter and may be unsafe for oncoming drivers due to glare. ![]() Go to the dealership and tell them you need a fog light bulb and low and behold, it will look just like your original. Yes, if you look at images for Osram H16's you will see a totally different bulb. The bulb for the Toyota fogs are the Osram H16's. H11 should be the correct bulb for your scott78945 I contacted the company and they are telling me that the H11's are the same as the H16's from previous. Obviously, when I went to install them I found that the 2014 actually has H16's. I didn't have my manual with me and the online selector said that I needed H11's.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |